SmartRoll® UnderStencil Wiping Rolls

for DEK Printers 

 

Click here to open a flyer on the DEK accessories

Most DEK printers use stencil rolls that are based on the same core tube, which is a plastic tube with a .75" inside diameter (19.5mm), that is 20.87" long (530mm). The typical roll outside diameter is 2.25", and it has 36 linear feet of paper per stencil roll. The full width roll has paper that is 20.12" wide (515mm), but some boards or printers are set up to accommodate a stencil roll with narrower width paper. It is important to make sure that when using a roll with paper that is not the full width that if a solvent bar system is being used, that the paper width is equal to or larger than the width of where the solvent is dispensed from the solvent bar. 

Rolls that fit various DEK (ASM) Printers

DEK Rolls

Core Length

Core ID

Roll OD

Paper Width

Feet Per Roll

Part #

4201DK

21.25" 

.75"

2.5"

21.25" (540mm)

36' (11M)

4202DK

20.87" 

.75"

2.25"

20.12" (511mm)

36' (11M)

4202DK-W

20.87" 

.75"

2.25"

20.12" (511mm)

36' (11M)

4202DK-45

20.87" 

.75"

2.25"

20.12" (511mm)

45' (14M)

4202DK-12

20.87" 

.75"

2.25"

12" (300mm)

36' (11M)

4202DK-14

20.87" 

.75"

2.25"

14" (350mm)

36' (11M)

4202DK-16

20.87" 

.75"

2.25"

16" (400mm)

36' (11M)

4205DK

24.25"

.75"

2.25"

24" (610mm)

36' (11M)

Note: Most rolls based on part # 4202DK will fit the DEK 265, 265GSX, 288, Horizon and Infinity model printers.

Click for roll material information page